ARTERY CL6

This error means the device cannot detect the coil. This is the most common technical issue for pod mods.

1. Check the Coil: Ensure the coil is screwed or pushed fully into the base of the pod.

2. Clean Contacts: Remove the pod and wipe the metallic contacts on both the bottom of the pod and inside the device with a dry tissue. E-liquid condensation is often the cause.

3. Replace the Coil: If the error persists after cleaning and tightening, the coil may be defective and needs replacement.

The ARTERY CL6 uses the specific [Manufacturer Coil Series Name/CL Coil Series] coils. Always check the side of your physical coil for the recommended wattage range.

• Low Resistance Coils (e.g., 0.6Ω): Use higher wattage (e.g., 25W–35W) for DTL (Direct-to-Lung) vaping.

• High Resistance Coils (e.g., 1.2Ω): Use lower wattage (e.g., 10W–15W) for MTL (Mouth-to-Lung) vaping.

The ARTERY CL6 typically features a built-in battery of [Insert mAh, e.g., 1500mAh].

• On/Off: Press the main firing button 5 times quickly.

• Lock/Unlock Wattage: Press the firing button 3 times quickly. This allows you to fire the device but prevents accidental wattage changes when in your pocket.

The ARTERY CL6 pod typically uses a top or side-fill system (look for the rubber plug).

1. Refilling: Open the rubber plug and fill the pod slowly. Do not overfill past 90% capacity—leave a small air bubble to maintain the internal vacuum.

2. Preventing Leaks: Always ensure the rubber fill plug is fully sealed after refilling. Wiping any excess e-liquid from the top of the pod before reinserting it into the device will prevent condensation buildup.